cable nut

Manufacturing A Corvette Cable Nut

Corvette Central manufactures many parts for Corvettes, including this cable nut for various control cables found on 58-62 Corvettes. Our three-step, in-house machining process is as follows:

Step 1 – We start by feeding a rough stock of brass through the barfeed in the first part of the lathe process.

Step 2 – Create a finishing length, then change the bit to add a smooth finish.

Step 3 – Mill the flats, in preparation for chroming.

Similar processes are used to fabricate the following SKUs:
451411
451415
451410
451416

Leave a Reply

Your email address will not be published. Required fields are marked *